Hood Latch Release Cable: Service and Repair

Hood Latch Release Cable Replacement

Removal Procedure

1. Open the hood.
2. Block the hood latch to prevent the hood from locking.
3. Disconnect the hood release cable from the hood latch by squeezing the hood release cable retainer.
4. Remove the side trim panel retainers.




5. Remove the hood latch release cable screws.
6. Remove the hood latch release cable handle from the front hinge pillar.

Important: Ensure the end of the wire or string remains in the passenger compartment.

7. Tie the wire or string to the end of the hood release cable in order to aid in the installation of the new hood release cable.




8. Remove the grommet from the engine compartment into the passenger compartment using a small flat-bladed tool.
Clean the old sealant from instrument panel hole.
9. Remove the hood release cable from the instrument panel.
10. Remove the wire or string from the hood release cable.




11. Remove the hood latch release cable (1).

Installation Procedure




1. Tie the wire or string to the hood release cable.
2. Install the hood primary latch release cable through the hole in the instrument panel.
3. Install the hood release cable through the instrument panel using a small flat-bladed tool until the grommet is fully seated.
4. Remove the wire or string from the hood release cable.
5. Install the hood latch release cable ball to the latch.
6. Install the hood latch release cable handle to the hinge pillar.






Notice: Refer to Fastener Notice in Service Precautions.

7. Install the hood latch release cable screws.

Tighten the hood latch release cable handle screws to 3 N.m (27 lb in).

8. Install the side trim panel retainers.