Sunroof / Moonroof Harness: Service and Repair
SUNROOF WIRING HARNESS REPLACEMENTREMOVAL PROCEDURE
1. Place the sunshade in the full forward position.
2. Remove the headlining trim finish panel as necessary.
3. Disconnect the electrical connector from the following components:
3.1. The sunroof control switch
3.2. The sunroof express module
3.3. The sunroof motor
3.4. The headliner electrical harness
IMPORTANT:
^ Note the location of the wiring harness.
^ Note the location of the tie-straps that secure the harness to the drive cables and to the sunroof module.
4. Cut the tie-straps and remove them.
5. Remove the wiring harness from the sunroof.
INSTALLATION PROCEDURE
1. Install the wiring harness to the sunroof.
2. Connect the electrical connector to the following components:
2.1. The sunroof control switch
2.2. The sunroof express module
2.3. The sunroof actuator
2.4. The headliner electrical harness
3. Install the tie-straps.
4. Install the headlining trim finish panel.
5. Inspect the sunroof for proper operation.