Brake Pedal Assy: Service and Repair

Brake Pedal Assembly Replacement

Removal Procedure





1. Remove the left closeout/insulator panel.
2. Disconnect the accelerator cable from the accelerator pedal.
3. Disconnect the brake pedal pushrod (1) from the brake pedal (2).





4. Remove the brake switch (1) from the brake pedal.
5. Disconnect the electrical harness from the brake pedal.





6. Remove the upper (1) and the lower (2) mounting nuts from the brake pedal assembly.
7. Remove the brake pedal assembly.

Installation Procedure





1. Install the brake pedal assembly.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the upper (1) and the lower (2) mounting nuts to the brake pedal assembly.
^ Tighten the mounting nuts to 27 Nm (20 inch lbs.).





3. Connect the brake pedal pushrod (1) to the brake pedal (2).
4. Connect the electrical harness to the brake pedal.
5. Install the brake switch (1) to the brake pedal.
6. Connect the accelerator cable to the accelerator pedal.
7. Install the left instrument panel insulator.