Front
Disc Brake Hardware Replacement - FrontRemoval Procedure
1. Remove the disc brake caliper bolts.
2. Using a c-clamp installed to the center of the outer disc brake pad and the back of the caliper, slowly compress the caliper piston into its bore just enough to remove the caliper from the mounting bracket.
3. Remove the disc brake caliper from the mounting bracket.
4. Remove the disc brake pads from the disc brake caliper bracket.
5. Remove the disc brake pad retainers from the disc brake caliper bracket.
6. Remove the caliper pins (5) from the disc brake caliper mounting bracket (3).
7. Remove the caliper pin boots (4) from the disc brake caliper mounting bracket.
8. Lightly wire brush all brake pad contact areas in order to remove any corrosion.
Installation Procedure
1. Install the caliper pin boots (4) to the disc brake caliper mounting bracket.
2. Install the caliper pins (5) to the disc brake caliper mounting bracket (3).
3. Install the disc brake pad retainers (4) to the disc brake caliper bracket.
4. Install the disc brake pads (5) to the disc brake caliper bracket.
5. Install the disc brake caliper (2) to the mounting bracket.
Notice: Refer to Fastener Notice in Service Precautions.
6. Install the disc brake caliper bolts (1).
^ Tighten the disc brake caliper bolts to 35 Nm (26 ft. lbs.).
Apply and release the brake pedal 3/4 stroke as many times as necessary in order to obtain a firm brake pedal.