Engine Compartment Fan: Service and Repair
Cooling Fan Replacement- ElectricRemoval Procedure
Caution: To help avoid personal injury or damage to the vehicle, a bent, cracked, or damaged fan blade or housing should always be replaced.
1. Remove the bolt, which retains the A/C line to the A/C line bracket.
2. Remove air deflector shield.
3. Remove electrical harness from retainers.
4. Disconnect the electrical connector.
5. Remove the 4 upper fan bolts.
6. Raise the vehicle. Refer to Vehicle Lifting.
7. Remove lower closeout panel.
8. Remove the 4 lower fan bolts.
9. Remove the fan from the shroud.
10. Remove the fan shroud from the vehicle.
Installation Procedure
1. Install the fan shroud.
2. Install the fan to the shroud.
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the lower fan bolts.
Tighten bolts to 10 Nm (89 inch lbs.).
4. Install the lower closeout panel.
5. Lower the vehicle.
6. Install the upper fan bolts.
7. Tighten the bolts to 10 Nm (89 inch lbs.).
8. Connect the electrical connectors.
9. Install air deflector shield.
10. Install bolt to retain A/C line bracket.
11. Tighten the bolts to 10 Nm (89 inch lbs.).