Harmonic Balancer - Crankshaft Pulley: Service and Repair

Crankshaft Balancer Replacement

^ Tools Required
- J 38122-A Harmonic Balancer Holder

Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.





2. Remove the front tire and wheel.
3. Remove the front fender liner.
4. Remove the engine drive belt.
5. Use J 38122-A to prevent the crankshaft from rotating while loosening the crankshaft balancer bolt.
6. Remover the crankshaft balancer bolt. Discard the bolt.





7. Remove the crankshaft balancer.

Installation Procedure





1. Install the crankshaft balancer.





2. Install a NEW crankshaft balancer bolt.

Notice: Refer to Fastener Notice in Service Precautions.

3. Use J 38122-A to prevent the crankshaft from rotating while tightening the crankshaft balancer bolt.
Tighten the bolt to 100 Nm (74 ft. lbs.) plus 75 degrees.
4. Install the engine drive belt.
5. Install the front fender liner.
6. Install the front tire and wheel.
7. Lower the vehicle.