61. Intake Manifold Installation
Intake Manifold InstallationNotice: Refer to Fastener Notice in Service Precautions.
1. Install the intake manifold studs in the manifold face.
Tighten the intake manifold studs to 6 Nm (60 inch lbs.).
Important: Gaskets must be clean. Swollen gaskets should be replaced.
2. Install a new intake manifold gasket on the intake manifold, if necessary.
3. Install the intake manifold.
4. Install the intake manifold bolts and nuts. Follow the tightening sequence.
Tighten the bolts and nuts to 10 Nm (89 inch lbs.).
5. Install the fuel rail assembly.
6. Install the fuel rail stud.
Tighten the stud to 10 Nm (89 inch lbs.).
7. Install new throttle body stud if necessary.
Tighten the studs to 6 Nm (60 inch lbs.).
8. Install the throttle body.
Tighten the bolts and nuts to 10 Nm (89 inch lbs.).
Important: Ensure that the rear metal tab of the EVAP emission canister valve is resting on the power steering pump metal body.
9. Install the EVAP emission canister valve (2).
Tighten the EVAP canister valve to 22 Nm (16 ft. lbs.).
10. Install the EVAP emission canister valve tube (1).