Blower Motor: Service and Repair
BLOWER MOTOR REPLACEMENTREMOVAL PROCEDURE
1. Remove the right side instrument panel (IP) insulator.
2. Reposition the BCM aside. Refer to Body Control Module Replacement in Body Control System.
3. Disconnect the blower motor electrical connector.
4. Remove the blower motor retaining screws.
5. Remove the blower motor and fan assembly.
INSTALLATION PROCEDURE
1. Install the blower motor and fan assembly.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the blower motor and fan assembly screws.
Tighten
Tighten the screws to 5 N.m (45 lb in).
3. Connect the blower motor electrical connector.
4. Install the BCM into position.
5. Install the right side IP insulator.