Turn Signal Lamp: Service and Repair

TAIL LAMP ASSEMBLY AND/OR BACKUP, SIDEMARKER, STOP, TURN SIGNAL BULB REPLACEMENT

REMOVAL PROCEDURE




1. Pull back the rear compartment trim.
2. Remove the tail lamp thumb nuts from the tail lamp.




3. Remove the tail lamp from the rear body panel.
4. Disconnect the electrical connector from the tail lamp.




5. Release the tabs to remove the circuit board from the tail lamp.
6. Remove the required bulbs from the sockets, if replacing bulbs.

INSTALLATION PROCEDURE




1. Install the required bulbs to the sockets, if replacing bulbs.
2. Install the circuit board to the tail lamp, pressing into place until the retainers are fully seated.




3. Connect the electrical connector to the tail lamp.




4. Position the tail lamp to the rear body panel.
5. Install the tail lamp thumb nuts, and hand tighten.
6. Fold the rear compartment trim to the original position.