Rear

Stabilizer Shaft Replacement

Removal Procedure





1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the rear right and the rear left stabilizer shaft link bolts (3).





3. Remove the stabilizer shaft insulator brackets (5) and the nuts (6) from the stabilizer shaft (2).
4. Remove the stabilizer shaft (2) from the vehicle.

Installation Procedure





1. Install the stabilizer shaft (2) to the vehicle.
2. Install the stabilizer shaft insulator brackets (5) to the stabilizer shaft (2) and the nuts (6). Do not tighten at this time.





Notice: Refer to Fastener Notice in Service Precautions.

3. Install the stabilizer shaft link bolts (3).
^ Tighten the link bolts to 69 Nm (51 ft. lbs.).
^ Tighten the stabilizer shaft insulator bracket nuts to 53 Nm (39 ft. lbs.).
4. Lower the vehicle.