Valve Body: Service and Repair

Control Valve Body Replacement

1. Remove the transmission side cover.





2. Remove the bolts (9, 12 and 16) from the control valve body assembly (18).
3. Remove the control valve body assembly (18).
4. Remove and discard the valve body to spacer plate gasket (22).





1. Install the control valve body to spacer plate gasket (22) onto the spacer plate (23).
2. Install the control valve body assembly (18) onto the gasket (22).





3. Inspect the TFP switch assembly (13) in order to verify the condition and correct location of the seven pressure switch O-rings.
4. If necessary replace the pressure switch O-rings.





5. Install the TFP switch assembly (13) onto the control valve body assembly.





6. Install the eighteen control valve body assembly bolts.

Notice: Refer to Fastener Notice in Service Precautions.





7. Hand start the bolts.
Tighten the bolts to 14 Nm (124 inch lbs.).
8. Install the transmission side cover.