Wiring Harness: Service and Repair

Wiring Harness Replacement

Removal Procedure

Tools Required
- J41101 Pass-Through Connector Remover

1. Remove the transmission side cover.





2. Push the J41101 onto the pass-through connector from the outside of the transmission case in order to compress the pass-through connector's retaining tabs.
3. With the retaining tabs compressed, use a screwdriver in order to remove the pass-through connector through the inside of the transmission case.
4. Remove the wiring harness (11).

Installation Procedure





Connect the wiring harness assembly to the following components:
- The TFP switch assembly (13)
- The pressure control solenoid (312) (red connector)

Important: The 1-2 shift solenoids wires are red and light green. The 2-3 shift solenoid wires are red and yellow.

- The 1-2 shift solenoid (305) (white connector)
- The 2-3 shift solenoids (305) (white connectors)
- The TCC solenoid (335)
- Install the transmission side cover.