Seals and Gaskets: Service and Repair

Axle Shaft Oil Seal Replacement

Tools Required
- J23129 Seal Remover
- J6125-B Slide Hammer
- J44385 Differential Bearing Race and Seal Installer
- J7079-2 Non-threaded Driver Handle

Removal Procedure
1. Raise and suitably support the vehicle. Refer to Vehicle Lifting.
2. Remove the front wheel and tire assemblies.
3. Remove the wheel driveshaft.





4. Use the J23129 and the J6125-B in order to remove the seal.
5. Inspect the seal bore for nicks or for burrs. Clean the bore with a fine grade sandpaper, if necessary.

Installation Procedure





1. Use the J44385 and the J7079-2 in order to install a new seal. Ensure that the seal is seated flush to the outer bore area.
2. Lubricate the seal with Dexron-III transmission fluid.
3. Install the wheel driveshaft.
4. Install the front tire and wheel assemblies.
5. Lower the vehicle.