Seat Back Bolster Replacement - Rear Split Folding

Seat Back Bolster Replacement - Rear Split Folding

Removal Procedure

1. Remove the rear seat cushion.




2. Remove the bolt from the lower U-bracket.
3. Lift up the seat back bolster to disengage the T-hook from the access hole in the rear shelf.
4. Remove the seat back bolster.

Installation Procedure




1. Pull the shoulder belt away from the seat back bolster area.
2. Align and engage the T-hook into the access hole in the rear shelf panel.
3. Pull on the top edge of the seat back bolster while pushing downward. This will properly engage the T-hook.

Notice: Refer to Fastener Notice in Service Precautions.

4. Install the bolt on the seat back bolster into the lower U-bracket.

Tighten the bolt to 12 N.m (106 lb in).

5. Install the rear seat cushion.