Console Replacement - Overhead (With Storage)

Console Replacement - Overhead (With Storage)

Removal Procedure

1. Remove the screw located by the windshield.
2. Insert a flat-bladed tool to the rear of the off/on switches and detach the console lamp assembly.
3. Disconnect the lamp electric connector.
4. Open the storage compartments.




5. Remove the overhead console screws.
6. Remove the overhead console housing.
7. Remove the backing plate.



Installation Procedure





1. Install the backing plate.
2. Install the overhead console housing.

Notice: Refer to Fastener Notice in Cautions and Notices.

3. Install the overhead console screws.

Tighten the overhead console screws to 2 N.m (18 lb in).

4. Install the screw located by the windshield.

Tighten the overhead console screw to 2 N.m (18 lb in).

5. Close the storage units.

6. Connect the lamp electrical connector.
7. Install the overhead console reading lamp.