Ambient Light Sensor: Service and Repair

DAYTIME RUNNING LAMPS (DRL) AMBIENT LIGHT SENSOR REPLACEMENT

REMOVAL PROCEDURE




1. Insert a small, plastic flat-bladed tool into the slot on the rear edge of the sensor bezel and release the bezel retainer from the I/P upper trim panel.
2. Remove the sensor bezel from the upper trim plate.




3. Remove the daytime running lamp (DRL) ambient light sensor (3) by turning counterclockwise to release the sensor from the sensor bezel.
4. Disconnect the electrical connector from the DRL ambient light sensor.

INSTALLATION PROCEDURE




1. Connect the electrical connector to the DRL ambient light sensor (3).
2. Install the DRL ambient light sensor to the sensor bezel. Rotate the sensor clockwise to secure.




3. Position the forward edge of the sensor bezel to the I/P upper trim panel.
4. Press the rear edge of the sensor bezel down until the rear retainers are seated correctly.