Oil Level Sensor: Service and Repair
Engine Oil Level Sensor and/or Switch ReplacementRemoval Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the engine oil drain plug and drain the engine oil.
3. Disconnect the engine oil level sensor electrical connector.
4. Remove the bolt from the engine oil level sensor.
5. Remove the engine oil level sensor from the oil pan.
Installation Procedure
1. Install the engine oil level sensor to the oil pan.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the engine oil level sensor bolt.
^ Tighten the bolt to 10 Nm (89 inch lbs.).
3. Connect the engine oil level sensor electrical connector.
4. Install the engine oil drain plug.
^ Tighten the plug to 25 Nm (18 ft. lbs.).
5. Lower the vehicle.
6. Fill the crankcase with engine oil.