Electric Park Lock Module - Assemble

Electric Park Lock Module - Assemble -Off Vehicle

- Tools Required
- J 41352 Modular Column Holding Fixture

Caution: Refer to SIR inflator module coil caution in Service Precautions.





1. Snap the electric park lock (2) onto the electronic lock module assembly (1).
2. Install the black connector into the electric park lock (2).





3. Install the upper trim cover (2) onto the steering column.

Notice: Refer to Fastener Notice in Service Precautions.

4. Install the 2 TORX head screws (1) into the upper trim cover (2).
- Tighten the screws to 1.5 Nm (13 inch lbs.).





5. Install the lower trim cover onto the upper trim cover in the following way:
5.1. Match the tab slots on the lower trim cover with the locking tabs on the upper trim cover.
5.2. Tilt the lower trim cover up.
5.3. Slide the lower trim cover forward until the locking tabs snap into the tab slots.





6. Install the 2 pan head tapping screws (1) into the lower trim cover (2).
- Tighten the screws to 3.5 Nm (31 inch lbs.).





7. Install the tilt knob (1) into the steering column.





8. Remove the steering column and J 41352 from the vise.
9. Install the steering column into the vehicle.
10. Install the steering wheel onto the steering column.
11. Enable the inflatable restraint steering wheel module.