Accelerator Pedal: Service and Repair

ACCELERATOR CONTROLS PEDAL REPLACEMENT

REMOVAL PROCEDURE




1. Remove the left instrument panel sound insulator.
2. Remove the accelerator cable (5) from accelerator pedal (1).
3. Remove the accelerated pedal bolt (3) and the stud (2).
4. Remove the accelerator pedal (1).

INSTALLATION PROCEDURE

IMPORTANT: The throttle should operate freely without binding between a full closed and a wide open throttle.




1. Position the accelerator pedal (1) to the bulkhead (4).

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the accelerator pedal bolt (3) and the stud (2).

Tighten
Tighten the bolt and the stud to 5 N.m (44 lb in).

3. Install the accelerator cable (5) to the accelerator pedal (1).
4. Inspect for complete throttle opening and closing positions by operating the accelerator pedal. Also inspect for poor carpet fit under the accelerator pedal.
5. Install the left instrument panel sound insulator.