Instrument Panel (IP) - Air Deflector/Louver - Right

REMOVAL PROCEDURE

IMPORTANT: In cold weather if the instrument panel (IP) pad is not at room temperature. Warm the IP pad around the air outlet deflector. This will allow the IP pad to become pliable for removal of the air outlet deflector.




1. If you will reuse the existing air outlet deflector, wrap the ends of the needle nose pliers with tape in order to avoid marring the surface of the air outlet deflector.




2. Remove the air outlet deflector from the IP by pulling from the right and left side of the air outlet deflector.

INSTALLATION PROCEDURE




1. Position the air outlet deflector to the instrument panel (IP).




2. Install the air outlet deflector to the IP by pressing into place until fully seated.
3. Inspect the air outlet deflector for proper movement.