Engine Support Fixture

Engine Support Fixture

^ Tools Required
- J 28467-90A Engine Support Adapters
- J 28467-B Universal Engine Support Fixture

Installation Procedure





1. Raise the hood.
2. Disconnect the negative battery cable.
3. Install the engine support adapters J 28467-9OA onto the strut attaching studs.





4. Install the strut tower support assemblies J 28467-5A over the engine support adapters J 28467-9OA.





5. Install the wing nuts to the engine support adapters J28467-9OA.





6. Install the strut tower tube J 28467-3 into the strut tower support assemblies J 28467-5A.





7. Install the 1/2 inch x 2.5 inch quick release pin J 28467-10 through the strut tower support assemblies J 28467-5A and the strut tower tube J 28467-3 on one side only.





8. Install the radiator shelf tube J 28467-2A on the top of the strut tower tube J 28467-3 on the driver side.
9. Install the round tube of the front support assembly J 28467-4A through the large hole in the radiator shelf tube J 28467-2A.





10. Install the 7/16 inch x 2.0 inch quick release pin J 28467-9 through the hole in the front support assembly J 28467-4A in order to level the radiator shelf tube J 28467-2A.





11. Install the cross bracket assembly J 28467-1 A.
12. Install the lift hook J 28467-7A through the lift hook bracket J 28467-6A.
13. Install the 1/2 inch lift hook washer and lift hook wing nut J 28467-34 onto the lift hook J 28467-7A.
14. Install the assembled lift hook bracket J 28467-6A over the passenger side radiator shelf tube J 28467-2A.





15. Adjust the passenger side radiator shelf tube J 28467-2A and the assembled lift hook bracket J 28467-6A in order to align the hook with the left, rear of engine, lift hook bracket attached to the left exhaust manifold.
16. Install the lift hook J 28467-7A through the lift hook bracket J 28467-6A.
17. Install the 1/2 inch lift hook washer and lift hook wing nut J 28467-34 onto the lift hook J 28467-7A.
18. Install the assembled lift hook bracket J 28467-6A over the strut tower tube J 28467-3.





19. Adjust the assembled swivel lift hook bracket J 28467-8A in order to align the hook with the right, front of engine, lift hook bracket attached to the right exhaust manifold.





20. Hand tighten the cross bracket assembly J 28467-1A wing nuts.
21. Hand tighten the lift hook wing nuts J 28467-34 securely to remove all slack from the engine support fixture assembly.