Turn Signal Cancel Cam & Steering Shaft Upper Bearing Spring

Turn Signal Cancel Cam and Steering Shaft Upper Bearing Spring Replacement On Vehicle

^ Tools Required
- J 23653-SIR Steering Column Lock Plate Compressor
- J 42137 Cam Orientation Plate Adapter

Removal Procedure
1. Disconnect the battery negative cable.

Caution: Refer to SIR Caution in Service Precautions.

2. Disable the SIR system.
3. Remove the inflator module.
4. Remove the steering wheel.
5. Remove the SIR coil from the steering column upper shaft.





6. Allow the SIR coil to hang.
7. Remove the wave washer (1) from the steering shaft (2).





8. Compress the shaft lock plate (2) using J 23653-SIR and J 42137.
9. Remove the bearing retainer (1) from the steering shaft.
10. Remove J 23653-SIR and J 42137 from the steering shaft.





11. Remove the shaft lock shield (5) from the steering shaft.
12. Remove the turn signal cancel cam (4) from the steering shaft.
13. Remove the upper bearing spring (3) from the steering shaft.
14. Remove the upper bearing inner race seat (2) from the steering shaft.
15. Remove the inner race (1) from the steering shaft.

Installation Procedure





1. Lubricate the inner race (1) with synthetic grease.
2. Install the inner race (1) onto the steering shaft.
3. Install the upper bearing inner race seat (2) onto the steering shaft.
4. Install the upper bearing spring (3) onto the steering shaft.
5. Lubricate the lower brass surface of the turn signal cancel cam (4) with synthetic grease.
6. Install the turn signal cancel cam (4) onto the steering shaft.
7. Install the shaft lock shield (5) onto the steering shaft.





8. Compress the shaft lock shield (2) using J 23653-SIR and J 42137.
9. Install the new bearing retainer (1) onto the steering shaft.
10. Firmly seat the bearing retainer (1) into the groove on the steering shaft.
11. Remove J 23653-SIR and J 42137 from the steering shaft.





12. Install the wave washer (1) onto the steering shaft (2).
13. Install the SIR coil.
14. Install the steering wheel.
15. Install the inflator module.
16. Enable the SIR system.
17. Connect the battery negative cable.