Sunroof Guide Replacement

REMOVAL PROCEDURE




1. Close the sunroof.
2. Remove the sunroof window.
3. Remove the sunroof module.
4. Remove the sunshade panel (3).
5. Remove the sunroof actuator (7).
6. Remove the rivets from the sunroof tube retainers, which are located on the motor bracket.
7. Remove the sunroof track screws.
8. Remove the tie wraps holding the drive tube (6) to the retaining tube (5).
9. Pull the cable out of the plastic return tube.
10. Remove the sunroof track and lifter arm assembly by pushing the track assembly inwards to loosen (9).
11. Remove the sunroof drive tube retainer (10) from the end of the track and the copper drive tube.

INSTALLATION PROCEDURE




1. Feed the sunroof drive cable through the copper drive tube.
2. Install the sunroof drive tube retainer with the copper drive tube into the track end.
3. Install the sunroof track and lifter arm assembly into the module frame.
4. Feed the sunroof drive cable through the plastic return tube.
5. Align the track parallel to each other with 666 mm between the left and right track at the front and rear of the track.

NOTE: Refer to Fastener Notice in Service Precautions.

6. Install the sunroof track screws.

Tighten
Tighten the screws to 4 N.m (35 lb in).

7. Install the sunroof cable wear plate (14).
8. Install the sunroof tube retainers to the motor bracket (10).
9. Install the rivet to the sunroof tube retainer.
10. Verify that the forward glass adjustment screw hole in the lifter arm is aligned with the small hole in the cable cam assembly. If required, push the lifter arm or the cable cam forward to align the two holes.
11. Install the sunroof actuator (7).
12. Tie wrap the drive (6) and return tubes (5) together.
13. Install the sunroof module.
14. Install the sunroof window.
15. Install the sunshade panel.