Crankshaft Position Sensor: Service and Repair

REMOVAL PROCEDURE

CAUTION: Refer to Vehicle Lifting Caution in Service Precautions.




1. Raise and support the vehicle.
2. Disconnect the crankshaft position (CKP) sensor harness connector.
3. Remove the CKP sensor retaining bolt.
4. Remove the CKP sensor from the engine block.

INSTALLATION PROCEDURE

IMPORTANT: Inspect the sensor O-rings for the following conditions:
^ Any wear
^ Any cracks
^ Any leakage

Replace the O-rings if necessary. Lubricate the new O-rings with engine oil before installation.




1. Install the CKP sensor into the engine block.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the CKP sensor retaining bolt.

Tighten
Tighten the bolt to 10 N.m (89 lb in).

3. Reconnect the CKP sensor harness connector.
4. Lower the vehicle.
5. Perform the CKP System Variation Learn Procedure. Programming and Relearning