Inflatable Restraint Instrument Panel Module Replacement
REMOVAL PROCEDURECAUTION: Refer to SIR Inflator Module Handling And Storage Caution in Service Precautions.
1. Disable the SIR system. Refer to Air Bag(s) Arming and Disarming.
2. Remove the I/P trim pad.
3. Remove the air distributor duct.
4. Remove the connector position assurance (CPA) from the inflatable restraint I/P module yellow 2-way pigtail connector.
5. Disconnect the yellow 2-way pigtail connector from the inflatable restraint I/P module.
6. Remove the mounting bolts (2) from the inflatable restraint I/P module (1).
7. Remove the inflatable restraint module (1) from the I/P.
INSTALLATION PROCEDURE
1. Install the inflatable restraint module (1) to the I/P.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the mounting bolts (2) to the inflatable restraint module.
Tighten
Tighten the bolts to 5 N.m (44 lb in).
3. Connect the yellow 2-way pigtail connector to the inflatable restraint module.
4. Install the connector position assurance (CPA) to the yellow 2-way pigtail connector on the inflatable restraint module.
5. Install the air distributor duct.
6. Install the I/P trim pad.
7. Enable the SIR system. Refer to Air Bag(s) Arming and Disarming.