Ignition Switch - Assemble

Ignition Switch Assembly - Assemble Off Vehicle

Tools Required
^ J41352 Modular Column Holding Fixture





1. Install the ignition switch assembly.

Notice: Refer to Fastener Notice in Service Precaution.

2. Install the 2 tapping screws.
Tighten the screws to 1.5 Nm (13 inch lbs.).





3. Remove the steering column and J41352 from the vise.
4. Install the steering column.
5. If necessary, install the multifunction switch.
6. Install the tilt lever.
7. Install the steering wheel.
8. Enable the inflatable restraint steering wheel module.