Radio Replacement

REMOVAL PROCEDURE




1. Remove the instrument panel (IP) accessory trim plate.
2. Remove the screws (2) from the radio.
3. Remove the radio (3) from the IP.
4. Disconnect the electrical connections (4) and the antenna coaxial cable (1) from the radio.
5. Remove the radio (3).

INSTALLATION PROCEDURE




1. Connect the electrical connections (4) and the antenna coaxial cable (1) to the radio.
2. Install the radio (3) to the IP.

NOTE: Refer to Fastener Notice in Service Precautions.

3. Install the screws (2) to the radio.

Tighten
Tighten the screws to 3 N.m (27 lb in).

4. Install the IP accessory trim plate.