Seat Replacement

Seat Replacement

Removal Procedure




1. Position the driver or the passenger front bucket seat forward or rearward in order to gain access to the seat adjuster attaching nuts (3).
2. Remove the seat adjuster stud covers (2) and seat adjuster nuts (3).
3. Disconnect the seat belt wire harness on the driver's side.
4. Remove the front bucket seat.

Installation Procedure




1. Install the seat to the vehicle.
2. Connect the seat belt wire harness on the driver's side.
3. Position the seat fully forward to gain access to the seat adjuster rear nuts (3).
4. Install the front bucket seat rear adjuster nuts (3).
Hand tighten the nuts.
5. Adjust the seat fully rearward.
6. Verify both lock bars are engaged in the most forward adjustment in the same notch on both of the seat adjusters.

Notice: Refer to Fastener Notice in Service Precautions.

7. Install the front bucket seat front adjuster nuts (3).

Tighten the nuts to 20 N.m (21 lb ft).

8. Adjust the front bucket seat to the full forward position and tighten the rear adjuster nuts.

Tighten the nuts to 20 N.m (21 lb ft).

9. Install the seat adjuster stud covers (2).