Instrument Panel Cluster (IPC) - Replacement

REMOVAL PROCEDURE




1. Remove the instrument panel (IP) trim pad.
2. Remove the screws (1 3) from the top of the IP cluster (2).
3. Remove the IP cluster (2) pulling rearward.
4. Disconnect the electrical connector (5) from the IP cluster (2).
5. Remove the IP cluster (2) from IP carrier.

INSTALLATION PROCEDURE




1. Connect the electrical connector (5) to the IP cluster (2).
2. Position the IP cluster retainer tabs (4) into the IP carrier.
3. Install the IP cluster (2) to the IP carrier.

NOTE: Refer to Fastener Notice in Service Precautions.

4. Install the IP cluster screws (1, 3).

Tighten
Tighten the screws to 2 N.m (18 lb in).

5. Install the IP trim pad.