Accelerator Pedal: Service and Repair

ACCELERATOR CONTROLS PEDAL REPLACEMENT

REMOVAL PROCEDURE




1. Release the cable (1) retainer from the accelerator pedal lever.
2. Remove the accelerator pedal assembly attaching nuts.
3. Remove the pedal assembly (2).

INSTALLATION PROCEDURE




1. Install the pedal assembly (2) to the cowl.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the nuts to the cowl.

Tighten
Tighten the nuts to 30 N.m (22 lb ft).

3. Install the accelerator cable (1) through the slot in the accelerator pedal assembly (2) and snap into place.
4. Inspect for correct opening and closing positions by operating the accelerator pedal. Ensure that the throttle valve reaches a wide open throttle (WOT) position. If the throttle valve does not open properly, inspect for damaged or bent brackets, levers, or other components. Also inspect for poor carpet fit under the accelerator pedal.