Wiper Motor Replacement

TOOLS REQUIRED
^ J 39232 Wiper Transmission Separator
^ J 39529 Wiper Transmission Installer

REMOVAL PROCEDURE
1. Remove the air inlet grille panel.
2. Remove the wiper drive system module.




3. Using the J 39232, disconnect the wiper transmission from the wiper motor crank arm.




4. Remove the wiper motor screws.
5. Remove the wiper motor from the wiper drive system module.

INSTALLATION PROCEDURE




1. Position the wiper motor to the wiper drive system module.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the wiper motor screws.

Tighten
Tighten the screws to 10 N.m (89 lb in).




3. Using the J 39529, connect the wiper transmission to the wiper motor crank arm.
4. Install the wiper drive system module.
5. Install the air inlet grille panel.
6. Inspect the wipers for proper operation.