Rubber Conduit Replacement - Rear Door

Rubber Conduit Replacement - Rear Door

Removal Procedure

1. Remove the rear door trim panel.
2. Remove the rear door water deflector as required.




3. Using a flat-bladed tool remove the conduit from the center pillar.
4. Using a flat-bladed tool remove the rubber conduit from the rear door.
5. Mark and remove the wires from the rear door power window switch, if equipped.
6. Mark and remove the connector from the rear lock.
7. Remove the wiring harness connectors (2) from the door panel.
8. Remove the wiring harness from the door.
9. Pull the harness through the rubber conduit.
10. Remove the rubber conduit from the door.

Installation Procedure




1. Pull the rear door electrical harness through the rubber conduit.
2. Position the harness in the door.
3. Install the rubber conduit to the rear door.
4. Install the rubber conduit to the center pillar.
5. Install the wiring harness connectors (2) to the door panel.
6. Install the wires to the rear door power window switch, if equipped.
7. Install the connector to the rear lock.
8. Install the rear door water deflector as required.
9. Install the rear door trim panel.