Instrument Panel (IP) - Trim Panel Replacement - Right

IP Trim Panel Replacement - Right

Removal Procedure




1. Open the instrument panel (IP) compartment door to access the RH IP trim panel (3).
2. Remove the IP accessory trim plate.
3. Remove the screws (1) from the RH IP trim panel (3).
4. Remove the RH IP trim panel (3) from the IP (2).

Installation Procedure




1. Position the RH IP trim panel (3) to the IP (2).

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the RH IP trim screws (1).

Tighten the screws (1) to 3 N.m (27 lb in).

3. Install the IP accessory trim plate.
4. Close the IP compartment door.