Instrument Panel (IP) - Trim Pad Replacement

Trim Pad Replacement - IP (Pontiac)

Removal Procedure




1. Disable the SIR system. Refer to Disabling the SIR System in Restraint Systems.
2. With a flat-bladed tool remove the defroster grille from the instrument panel (IP) trim pad.
3. Remove the IP upper trim panel (4) by lifting upward to release the retainers.
4. Remove the IP outer trim cover screws.
5. Remove the IP outer trim covers.
6. Remove the IP accessory trim plate.
7. Remove the right IP trim panel screws (1).
8. Remove the right IP trim panel (3).
9. Remove the screws (1) attaching the IP trim pad (2).
10. Remove the IP trim pad (2) from the IP carrier.

Installation Procedure




1. Install the IP trim pad (2) to the IP carrier.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the screws (1) attaching the IP trim pad (2) to the IP carrier.

Tighten the screws to 2 N.m (18 lb in).

3. Install the right IP trim panel (3).
4. Install the screws to the right IP trim panel (1).

Tighten the screws to 3 N.m (27 lb in).

5. Install the IP accessory trim plate.
6. Install the IP outer trim covers.
7. Install IP outer trim cover screws.

Tighten screws to 2 N.m (18 lb in).

8. Install the IP upper trim panel (4) by pushing downward until retainer are fully seated.
9. Install the defroster grille to the IP carrier.
10. Enable the SIR system. Refer to Enabling the SIR System in Restraint Systems.