Enabling

1. Connect the inflatable restraint IP module connector.
2. Install the Connector Position Assurance (CPA) to the inflatable restraint IP module pigtail connector.
3. Install the IP trim pad.




4. Connect the inflatable restraint steering wheel module coil connector (1).
5. Install the CPA to the inflatable restraint steering wheel module coil connector, located under the instrument panel, left of the steering column.




6. Install the AIR BAG Fuse to the LH IP wiring harness junction block.
7. Install the LH IP outer trim cover.
8. Staying well away from both air bags, turn ON the ignition.
8.1. The AIR BAG indicator will flash 7 times.
8.2. The AIR BAG indicator will then turn OFF.
9. Perform Diagnostic System Check - Restraint Systems if the AIR BAG indicator does not operate as described.