SIR Steering Wheel Module Coil - Assemble
Inflatable Restraint Steering Wheel Module Coil - Assemble - Off VehicleTools Required
^ J41352 Modular Column Holding Fixture
1. Align the block tooth on the race and upper shaft assembly to the 12 o'clock position.
2. Turn the key to the OFF position and remove the key.
3. Install the wave washer (2).
4. If you are reusing the original coil (1), center the coil.
Important: A new inflatable restraint steering wheel module coil (1) will be pre-centered. Do not remove the centering tab from the new inflatable restraint steering wheel module coil (1) until the installation is complete.
5. Install the new inflatable restraint steering wheel module coil download to the wire restraint clip (3).
6. Align the inflatable restraint steering wheel module coil (4) with the horn tower on the turn signal cancel cam assembly (1).
7. Slide the inflatable restraint steering wheel module coil (4) onto the steering shaft assembly (2).
8. Firmly seat the retaining ring (3) into the groove on the steering shaft assembly (2).
9. Remove the centering tab from the new inflatable restraint steering wheel module coil (4).
Caution: Refer to SIR Inflator Module Coil Caution in Service Precautions.
10. Install the wire harness straps to the wire harness assembly.
11. Remove the steering column and J41352 from the vise.
12. Install the steering column.
13. Install the tilt lever.
14. Install the steering wheel.
15. Enable the inflatable restraint steering wheel module.