Wiper Gear Box: Service and Repair
WIPER TRANSMISSION REPLACEMENTTOOLS REQUIRED
^ J 39232 Wiper Transmission Separator
^ J 39529 Wiper Transmission Installer
REMOVAL PROCEDURE
1. Remove the air inlet grille panel.
2. Remove the wiper drive system module.
3. Using the J 39232, disconnect the wiper transmission from the wiper motor crank arm.
4. Remove the wiper transmission caps.
5. Remove the wiper transmission screws.
6. Remove the wiper transmission from the wiper drive system module tube frame.
INSTALLATION PROCEDURE
1. Position the wiper transmission to the wiper drive system module tube frame.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the wiper transmission screws.
Tighten
Tighten the screws to 9 N.m (79 lb in).
3. Install the wiper transmission caps.
4. Using the J 39529, connect the wiper transmission to the wiper motor crank arm.
5. Install the wiper drive system module.
6. Install the air inlet grille panel.
7. Inspect the wipers for proper operation.