Turn Signal Cancel Cam and Steering Shaft Upper Bearing Spring
Turn Signal Cancel Cam and Steering Shaft Upper Bearing Spring ReplacementTools Required
^ J23653-SM Lock Plate Compressor
Removal Procedure
Caution: Refer to SIR Caution in Service Precautions.
1. Disable the SIR system.
2. Remove the knee bolster.
3. Remove the steering wheel.
4. Remove the SIR coil.
5. Remove the steering column trim covers.
6. Using J23653-SIR remove the bearing retainer.
7. Remove the shaft lock shield assembly (1).
8. Remove the turn signal cancel cam assembly (2).
9. Remove the upper bearing spring (3).
Installation Procedure
1. Install the upper bearing spring (3).
2. Install the turn signal cancel cam assembly (2).
3. Install the shaft lock shield assembly (1).
4. Install the bearing retainer.
5. Using J23653-SIR depress the shaft lock shield assembly.
6. Push the bearing retainer into place.
7. Remove J23653-SIR from the steering shaft.
8. Install the steering column trim covers.
9. Install the SIR coil.
10. Install the steering wheel.
11. Install the knee bolster.
12. Enable the SIR system.