Zone 8

1. Turn the steering wheel so that the vehicle's wheels are pointing straight ahead.
2. Turn the ignition switch to the OFF position.
3. Remove the key from the ignition switch.




4. Remove the rear seat.
5. Locate the rear fuse center under rear seat, then remove the fuse center top cover.
6. Locate and remove the SIR fuse from the rear fuse center.

IMPORTANT: With the SIR fuse removed and the ignition switch in the ON position, the AIR BAG warning indicator illuminates. This is normal operation, and does not indicate an SIR system malfunction.




7. Remove the Connector Position Assurance (CPA) (1) from the RF/passenger side impact module yellow connector (3) which is located under the passenger seat.
8. Disconnect the vehicle harness yellow connector (2) from the RF side impact module yellow connector (3).




9. Remove the right insulator panel.
10. Remove the CPA (4) from the vehicle harness yellow connector (2) located below I/P (3).
11. Disconnect the I/P module yellow connector (1) from the vehicle harness yellow connector (2).




12. Remove the left insulator panel.
13. Remove the CPA (1) from the steering wheel module coil yellow connector (4) located near the steering column (2).
14. Disconnect the steering wheel module coil yellow connector (4) from the vehicle yellow harness connector (3).




15. Remove the CPA (3) from the LF/driver side impact module yellow connector (1) which is located under the driver seat.
16. Disconnect the vehicle harness yellow connector (2) from the LF side impact module yellow connector (1).