95. Engine Prelubing

Engine Prelubing

Tools Required
J 45299 Engine Preluber

Important: A constant/continuous flow of clean engine oil is required in order to properly prime the engine. Be sure to use an approved engine oil as specified.

Notice: Refer to Fastener Notice in Service Precautions.

1. Remove the engine oil filter fill with clean engine oil, and reinstall.

Tighten the oil filter to 30 N.m (22 lb ft).





2. Locate the oil pressure sensor (1) on left side of engine and remove.

3. Install the 1/4 inch adapter PIN 509373.





4. Install the flexible hose to the adapter and open the valve.

5. Pump the handle on J 45299 to flow a minimum of 1-2 quarts of engine oil. Observe the flow of engine oil through the flexible hose and into the engine assembly.

6. Close the valve and remove the flexible hose and adapter from the engine.

7. Install the oil pressure sensor.

Tighten the oil pressure sensor to 16 N.m (12 lb ft).

8. Top off the engine oil to the proper level.