Fluid - A/T: Service and Repair

Automatic Transmission Fluid/Filter Replacement

^ Tools Required
- J 6125-1BSlideHammer
- J 23129 Universal Seal Remover
- J 36850 Transmission Assembly Lubricant

Removal Procedure





1. Raise and support the vehicle. Refer Vehicle Lifting.
2. Place the drain pan under the transaxle oil pan.

Notice: When removing the oil pan bolts, be careful not to damage the oil pan sealing surfaces. Such damage may result in oil leaks in this area.

3. Remove the oil pan bolts from only the front and the sides.
4. Loosen the rear oil pan bolts about 4 turns.
5. Lightly tap the oil pan with a rubber mallet or pry in order to allow the fluid to drain.
6. Inspect the fluid color.
7. Remove the remaining oil pan bolts.





8. Remove the oil pan (24) and the gasket (25).





9. Remove the oil filter. Use a long screwdriver in order to pry the oil filter neck out of the seal.
10. Check the oil filter seal for damage or wear.
11. As needed, remove the seal using the J 6125-1B and the J23129.

Installation Procedure





1. Install a new seal, as needed. Before installing, coat the new seal with a small amount of J 36850 or petroleum jelly.
2. Install a new filter into the case.

Important: Oil pan gaskets are reusable. Only replace if sealing surface is damaged.





3. Install the oil pan (24) and the gasket (25) at the same time.

Notice: Refer to Fastener Notice in Service Precautions.





4. Install the oil pan bolts.
^ Tighten the bolts to 14 Nm (125 inch lbs.).
5. Lower the vehicle.
6. Fill the transaxle to the proper level.
7. Inspect the transmission fluid level.
8. Inspect the oil pan gasket for leaks.