Seat Replacement - Front Bucket

Seat Replacement - Front Bucket

Removal Procedure




1. Position the front seat forward in order to gain access to the seat adjuster bolts (1).
2. Remove the bolts (1) from the back of the adjuster (3).
3. On the driver side disconnect the seat belt wiring harness.
4. Disconnect the power seat electrical connector, if equipped.
5. Place the seat back in a full recline position.
6. Manually tilt the seat assembly at an angle to disengage the seat adjuster hooks adjuster from the floor pan.
7. Remove the seat assembly from the vehicle.

Installation Procedure




1. Position the seat into the vehicle.
2. Align the seat adjuster hooks to the openings in the floor pan.
3. Manually tilt the seat assembly at an angle in order to engage the hooks into the floor pan.
4. Place the seat back in a full upright position.
5. Connect the power seat electrical connector, if equipped.
6. On the drivers side connect the seat belt wiring harness.
7. Position the seat assembly forward in order to gain access to the adjuster bolts (1).

Notice: Refer to Fastener Notice in Service Precautions.

8. Install the front seat adjuster bolts (1).

Tighten the bolts to 41 N.m (30 lb ft).