Radio Replacement

RADIO REPLACEMENT

REMOVAL PROCEDURE




1. Remove the instrument panel (I/P) accessory trim plate.

IMPORTANT: Perform the radio set up procedure for new and reinstalled radios.

2. Remove the radio screws.
3. Pull the radio toward you for access to the connectors.
4. Disconnect the I/P wiring harness connectors and the antenna cable connector from the radio.
5. Remove the radio from the I/P.

INSTALLATION PROCEDURE




1. Position the radio to the I/P.
2. Connect the I/P wiring harness connectors and the antenna cable connector to the radio.
3. Align the radio locator tab to the I/P locator opening. Install the radio.

IMPORTANT: If the radio locator tab is difficult to align to the I/P locator opening, pull the radio toward you and reposition the antenna cable.

4. Install the radio screws.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten
Tighten the radio screws to 2 N.m (18 lb in).

5. Install the I/P accessory trim plate.
6. Perform the radio set up procedure for new and reinstalled radios.