Power Sunroof Inoperative

POWER SUNROOF INOPERATIVE

TEST DESCRIPTION

Steps 1-2:

Steps 3-6:

Steps 7-9:

Steps 10-14:

Steps 15-21:

Steps 22-24:

Steps 25-31:

Steps 32-40:

The number below refers to the number on the diagnostic table.
7. Using a jumper wire to short the sunroof limit switch soft stop signal circuit to a good ground, will simulate that the glass is in a position that will allow it to slide in either direction. This will allow any request from the sunroof switch to the sunroof module to supply an output to drive the sunroof motor.