Sunroof Motor/Actuator Initialization/Teach Process (New Motor)

Sunroof Motor/Actuator Initialization/Teach Process (New Motor)

Perform the Initialization/Teach Procedure any time a new sunroof motor actuator is installed in the vehicle.

1. Ensure that the electrical harness on the headliner is connected to the sunroof.
2. Press the sunroof switch to the close position until the window stalls at the front hard stop in the fully close position, then moves slightly toward the soft stop position. Release the switch.
3. Within 6 seconds, press and hold the switch in the close position. After an additional 3 seconds, the sunroof window will move toward the open position.
4. Hold the switch until the sunroof window stops at the closed position. Release the switch.
5. Inspect for proper operation of the sunroof. Refer to Sunroof Description and Operation Description and Operation.

Important: The Initialization/Teach Procedure is not complete if any of the following actions take place before the initialization cycle is done:
- The sunroof switch is not held in the closed position.
- The ignition and/or battery power has been removed.
- The glass panel has not reached the closed position.

The Initialization Procedure must be restarted if the procedure is not carried out completely.