B0689
DTC B0689CIRCUIT DESCRIPTION
The SECURITY indicator lamp notifies the driver of the vehicle theft deterrent (VTD) system status. The theft deterrent control module controls the operation of the SECURITY indicator lamp. The SECURITY indicator lamp is part of the instrument panel cluster. Based on system status the SECURITY indicator may remain OFF, illuminate ON steady, or FLASH.
CONDITIONS FOR RUNNING THE DTC
The ignition is ON.
CONDITIONS FOR SETTING THE DTC
The theft deterrent control module detects a low current condition in the SECURITY indicator lamp control circuit for one second.
ACTION TAKEN WHEN THE DTC SETS
- DTC B0687 and DTC B0689 cycle as current DTCs every five seconds in the theft deterrent control module.
- DTC B0687 and DTC B0689 are set as a history DTC in the theft deterrent control module's non-volatile memory.
CONDITIONS FOR CLEARING THE MIL/DTC
- The theft deterrent control module no longer detects an low current condition in the SECURITY indicator lamp control circuit.
- A history DTC will clear after 100 consecutive fault free ignition cycles.
- Using a scan tool in order to clear a history DTC.
DIAGNOSTIC AIDS
Refer to Diagnostic Aids for Circuit Testing and Wiring Repair procedures.
TEST DESCRIPTION
Steps 1- 3:
Steps 4 - 10:
Steps 11 - 13:
The numbers below refer to the step numbers on the diagnostic table.
2. This DTC will set when there is a short to ground in the SECURITY indicator control circuit. Diagnose DTC B0687 if set as a current code before diagnosing DTC B0689.
3. Verifies the condition for setting the DTC is current.
5. Checks for an open in the security indicator control circuit or for a faulty theft deterrent control module module.
6. Checks for an open bulb filament.