Power Trunk / Liftgate Lock Actuator: Service and Repair
RELEASE ACTUATOR REPLACEMENTREMOVAL
1. Open the rear compartment lid.
2. Disconnect the electrical connector from the lock actuator.
3. Remove the lock actuator to the rear compartment lid latch bolts.
4. Remove the lock actuator from the rear compartment lid latch.
INSTALLATION
1. Align the lock actuator to the rear compartment lid latch.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the lock actuator bolts.
Tighten
Tighten the lock actuator bolts to 3 N.m (26 lb in).
3. Connect the electrical connector to the lock actuator.
4. Close the rear compartment lid.