Seat Back Replacement - Front
SEAT BACK REPLACEMENT - FRONTREMOVAL PROCEDURE
1. Remove the front seat.
2. Remove the front seat trim panel.
3. Disconnect the electrical connectors, as required.
4. Unfasten the J-retainer on the outboard side of the seat cushion cover.
5. Slide up the sewn side of the cushion cover up in order to expose the recliner/seat back attachment.
6. Remove the roll pins from the hinge supports and the recliner.
Discard the roll pins.
7. Remove the recliner to seat frame pivot bolts.
8. Remove the front seat back from the front seat.
INSTALLATION PROCEDURE
1. Install the front seat back to the front seat.
2. Install the recliner to seat frame pivot bolts.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the recliner to seat frame pivot bolts to 24 N.m (18 lb in).
3. Install the new roll pins to the hinge supports and recliner.
4. Fasten the J-retainer on the outboard side of the seat cushion cover.
5. Connect the electrical connectors, as needed.
6. Install the front seat trim panel.
7. Install the front seat.