Drive Cable Replacement - Horizontal and Vertical

DRIVE CABLE REPLACEMENT - HORIZONTAL AND VERTICAL

REMOVAL PROCEDURE
1. Remove the power seat adjuster.




2. Remove the cables by squeezing the oblong connector at the motors and the vertical/horizontal actuators.

IMPORTANT: Initial removal of the nut securing the motor support bracket is suggested to gain access to the cable connector at motor for the inboard, passenger side or the outboard, driver side rear vertical gearnut.

3. Carefully flex the cable and remove it from the motor and horizontal/vertical actuator.

INSTALLATION PROCEDURE




1. Carefully flex the cables and install them to the motors and horizontal/vertical actuators.
2. Firmly push the oblong connector at the end of the horizontal and vertical drive cables into the motors.
3. Install the power seat adjuster.