Valve Spring: Service and Repair

Valve Stem Oil Seal and Valve Spring Replacement

- Tools Required
- J 22794 Spark Plug Port Adapter
- J 38606 Valve Spring Compressor
Removal Procedure







Important: Before you remove the valve locks, rotate the engine so that the piston in the cylinder you are working on is at top dead center (TDC). This will eliminate the possibility of the valve accidentally falling inside the cylinder.
Break the spark plug loose, and clean any dirt or debris from the spark plug recess area before removing.
Do not remove the spark plug when the engine is hot.

1. Remove the spark plug from the cylinder that is being serviced.
2. Remove the rocker arm.
3. Install the J 22794 to the spark plug port. Apply compressed air in order to hold the valves in place.
4. Install the J 38606 on the valve spring.







5. Compress the valve spring with the J 38606.







6. Remove the valve locks.
7. Remove the valve cap.
8. Remove the valve spring.
9. Inspect the valve spring for damage.
10. Remove the spring seal/valve stem oil seal.



Installation Procedure







1. Install the valve stem oil seal/spring seat.
2. Install the valve spring.
3. Install the valve cap.







4. Compress the valve using the J 38606.
5. Install the valve locks. If necessary, hold the valve locks in place with grease.







6. Release the valve spring using the J 38606.
7. Make sure that the valve locks are seated.
8. Release the air pressure and remove the J22794 from the spark plug port.
9. Install the valve rocker arm.
10. Install the spark plug.